2021 X-Yachts Xp 55

• Built in sandwich construction with structural foam core
• Bi-directional and uni directional E-glass strategically positioned for strength and weight optimization
• Solid laminate in high stress areas in way of keel top, stern gear and rudder tube
• Outer surface of hull in white sprayed Gelcoat (RAL 9010 white) with 3 waterlines in dark blue Gelcoat (RAL 5011 dark blue)
• Hull epoxy infused in female moulds for optimum consolidation and high quality surface finish
• Structural bulkheads in marine plywood varying in thickness from 16-24 mm laminated to hull
• Structural hull liner bonded into hull. Carbon fiber reinforcements to absorb all loads from keel and mast
• Single point lift attachment eye for easy and safe lifting and launching of the yacht - see extra for polyester strap and shackle.
• Aft tender garage to accommodate inflatable tender. (Size Lmax = 320 cm, Bmax= 160 cm, Hmax = 65 cm),Transom door electrically operated
• Bathing ladder in stainless steel to be hooked onto transom door when lowered - stored in aft cockpit locker
• Hull recessed portlights - Rectangular (6 pcs)

• Polyester deck with structural foam core
• E-glass with bi and uni-directional cloth strategically positioned for strength
• Outer surface of deck in white sprayed gelcoat (RAL 9010)
• Deck and locker lids moulded in female moulds for highest quality surface finish
• Teak, vacuum applied, 9 mm nominal thickness on cockpit sole and seats
• Safety toerail incorprated in deck design forward, tapers down aft for comfortable hiking
• Anchor locker - drained area with windlass and space for anchor chain
• Sail Cabin - aft of the anchor locker with space for general storage
• Gas locker for 2 x 3 kg gas bottle located in side deck
• Gas spring fitted to sail locker, forward and aft cockpit lockers (4 pcs)
• Foot chocks - deck recessed aft of steering wheels
• Integrated rope compartments in front of steering wheels, port and starboard, under side deck
• Cockpit floor locker with hinged lid, with space for optional cockpit table and liferaft storage below - Max size of liferaft 800 x 500 x 325

• Xp 55 - Three cabin layout with heads situated in owner's cabin and STB aft
• The interior consists of a combination of white composite and wooden units.
• Utilising first class craftmanship and lamination techniques
• Hand selected, top grade, veneer throughout yacht, hand polished and varnished to satin finish
• Veneered bulkheads
• White laminate bulkheads used inside bathrooms, on aft bulkhead and longitudinal bulkheads under cockpit floor
• GRP deck head liner throughout with integrated light fittings. White vinyl panels on coachroof sides and deck head in the main cabin
• Oceanair blinds incl flyscreen fitted to skylights (9 pcs)
• Sliding curtains fitted to hull windows in owners and aft cabins (4 pcs)
• GRP hull liner including heads floor and shower trays
• Floorboards of 16 mm marine plywood with imitated teak and Gaboon plywood inlay stripes and inspection hatches to access bilge
• Companionway (GRP moulding) with steps of curved unvarnished teak
• Handrails by entrance and alongside coach roof portlights in main cabin in stainless steel

Standard owner's cabin with berth on center line

• Large double centre berth. Marine plywood mattress supports. Mattresses in 15 cm comfort foam. Max size 201 x 160 cm
• Seat with backrest cushion to port & starboard
• Large, white, double composite wardrobe (95 cm wide) with shelves and hangers on starboard
• Freeboard cupboards and shelves above berth
• 2 large drawers below owner's berth for bedding
• Freeboard lined with white vinyl covered panels

Main cabin

• To port: U-shaped 6 seater sofa (240 cm x 132 cm) surrounding dining table
• Two-seater settee bench in centre in veneer with a white kickback
• Main cabin table (133 cm x 81 cm) - mounted on two aluminium legs. GRP storage box below
• To starboard: Dedicated navigation table (71 cm x 95 cm) with storage and navigationale stationary and instruments and navigator's seat with storage space for additional navigational and emergency equipment.
• Long sofa with veneer front panels on sofa front
• Overhead lockers with bottom hinged openings running full length of saloon
• Electrical switch board located above chart table on overhead lockers.
• Additional space for electronic instruments, plotter and communication equipment. 230V AC distribution panel below chart table
• Pleated curtains for hull windows in main cabin hidden behind hull side soft panneling - 4 pcs
• Freeboard lined with white vinyl covered panels

Standard aft Cabins

• Large double berths (205 cm x 158 cm, max width) Marine plywood mattress support with ventilation holes. Mattresses 120 mm comfort foam
• Large white double composite wardrobe (90 cm wide) with shelves and hangers in both aft cabins
• Port cabin: Additional wardrobe and stool seat
• Freeboard shelves above berth fitted in each aft cabin
• Freeboard lined with vinyl

Head & Shower Compartments (Standard with starboard aft cabin and owner's cabin)

• Bulkheads covered with white laminate
• Tabletops and integrated sinks in a white composite moulding
• Single lever mixer tap for shower. Head bracket to hold shower hose/shower head
• Shower mixers with shower heads mounted on adjustable shower holders
• Electrical shower sump pump with sensor for automatic operation
• Unvarnished teak panels recess into shower and toilet floors
• Towel rails and grab handles running around table tops in stainless steel
• Towel hooks and toilet roll holders
• Mirrors above sinks

• Main engine - Yanmar 110 HP (4JH4) turbo charged, shaft drive made of high tensile corrosion resistant stainless steel. Freshwater cooled diesel engine mounted on rubber suspension on heavy GRP built engine bed.
• Extra 24V Alternator fitted on main engine for charging service battery bank
• Special engine compartment with sound insulation ensures low noise level in yacht
• Engine easily accessible for service at the forward end, through companionway steps; and side via the aft cabins
• 3-bladed Flex-O-Fold Propeller mounted on shaft
• Engine control panel and throttle/gear lever placed in starboard cockpit coaming. Engine control panel incorporates rpm meter, hour counter, acoustic alarm for oil pressure and cooling water temperature
• Fuel tank 400 ltr. in aluminium mounted below floor board in saloon. Shut off valves on all supply and return lines, level gauge with analogue meter in panel.
• Fuel filter/water separator fitted in engine room for main engine supply line.
• Stainless steel deck fill and ventilation via pushpit
• Alarm and warning light activated in cockpit when consumption tank needs refilling

• Galley, white high gloss composite moulding, U-shaped (295 cm x 180 cm).
• Extra Large table top made in black Corian
• Black corian counter top island - situated inboard side 85 x 32 cm
• Sink, rectangular recessed stainless steel with single lever mixing tap (2 pcs) with 2 cuttingboards made of Delrin material
• Cool box, GRP top opened 140 litres with 100 mm insulation, built in Isotherm
• SP accumulator plate cooled by water cooled Danfoss compressor with seacock and zink anode
• Gas stove, ENO, with 3 jets and oven is gimballed (1 pcs)
• Additional storage incl. space for optional washing machine
• Shelves, drawers and lockers with plexi glass sliding doors provide storage space for cutlery and food
• Microwave oven with stainless steel front fitted in galley
• White laminate finished lockers provide storage space for crockery and food
• 10 mm hardened glass splash board
• Waste bin mounted under sinks

• 24V DC system throughout yacht
• X-Yachts main switch board with 33 automatic fuses and 3 analogue VDO meters for fuel, water and battery voltage, separate 1 x 230V socket and 1 x 12V socket mounted at nav station
• All cabling terminates in “dry” GRP box fitted behind main electrical panel for added safety
• 12V DC system for main engine installation
• Service battery: Maintenance free AGM service battery bank 24 V@360 Ah
• Engine battery: Engine spiral-cell battery (55 Ah, 12 V) mounted near main engine for starting of engine and optional generator only. Engine battery is charged by either main engine or generator
• Shore power installation with shore power inlet mounted in cockpit protected by 10A main fuse. 230V AC distribution box located at nav. station with integrated ground fault circuit breaker/10A fuse, 1 x 230V AC socket and switches for hot water immersion heater and battery charger
• Three stage battery charger 24V/50A, incl. Battery monitor mounted
  12V halogen courtesy lights fitted for general purpose below deck throughout cabins
• 4 x LED flex arm reading lights fitted in main cabin and at chart table
• General lights and dome spotlights integrated in inner liner
• Light in engine room and optional generator compartment
• Reading lights throughout aft cabin, main cabin and owner's cabin (No: 8)

• Fractional tripple spreader keel stepped mast, tapered silver anodized aluminium, specially designed for Xp 55
• Steaming light LED, Windex with light, tube for additional electrical equipment and 2 mast steps fitted
• Silver anodized boom with 2 reef lines and internal boom outhaul, telescopic vang and outer purchase block system

Standing Rigging

• Standard Backstay: Split backstay with turnbuckle in one side, and a hydraulic integral backstay adjuster on the other side
• Stainless steel chain plates securely bolted through the hull freeboard and neatly covered with a GRP plate (2 pcs)
• Discontinuous stainless steel rod rigging with rod turnbuckles
• Rod forestay with Profurl furling drum under deck, furling line run below deck surface to one of the cockpit winches
• Chain plates in stainless steel for forestay and split backstay (3 pcs)

Running Rigging (Spectra sheets and polyester control and reefing lines:)

• Spectra halyards led back to cockpit for easy handling:
• Main halyard 14 mm
• Genoa halyard 14 mm
• Mast head spinnaker halyard 14 mm
• Spectra sheets and polyester control and reefing lines:
• Furling control line 8 mm
• Outhaul 8 mm
• Vang control line 8 mm
• Reef 1 10 mm
• Reef 2 10 mm
• Cunningham at mast with block and cleat system - 8 mm
• Mainsheet 12 mm
• Genoa Sheet 14 mm - 2 pcs

• 1 x Flag pole, teak with bronze bushing
• 1 x 25 m shore power cable
• 1 x 3 kg gas bottle
• 5 x Fire extinguishers, dry powder of 2 kg each, fitted throughout the yacht and
• 1 x fire blanket
• 1 x Rope ladder for emergency boarding of yacht
• 4 x Fenders, white air-filled with lanyards and X-Yachts logo
• 2 x Mooring ropes, polyester 20 m x 16 mm